BENDIX TCH-013-004 Manual do Utilizador descarregar pdf (Página 3)

Spade Terminal

Wire Cutter

Controller Ground

Wires (2)

Figure 3 Cutting Spade terminal from ground wires

3. Cut the spade connector from the two ground wires and strip 1/4" of insulation from the wires (see figure 3).

1/4” Ring Terminal

Controller Ground

Wires (2)

Figure 4 Installing Ring terminal on ground wires

4. Install both ground wires in a single, 1/4" ring terminal and crimp the terminal on the wires (see figure 4).

Ground Screw in

center floor of

Voltage Box

Controller Ground

Wires (2)

Figure 5 Installing Ring terminal ground screw

5. Reroute the two ground wires (with ring terminal installed) to the ground screw on the center of the floor in

the voltage box and bolt the ring terminal to this ground point (see figures 1 & 5). The green LED on the

AntiLock controller should now be illuminated when the vehicle is “powered up”.

6. Perform the Antilock “Initial Start-Up” Procedure.

1 2 3

Sem comentários

BENDIX TCH-013-004 Manual do Utilizador Página 3