BENDIX GEN 4 GEN 5 ABS Manual do Operador descarregar pdf (Página 35)

Selecting a Protocol & Registering the ECU

NEXIQ Brake-Link™ Bendix

& Eaton

ABS Applications 29

Press ; refer to Chapter 3, "Diagnosing EC-17, EC-30 & EC-30T

ABS" or Chapter 4, "Diagnosing Gen 4 & 5 ABS".

7 Brake-Link™ instructs you to CONTINUE BY PRESSING BUTTONS.

Refer to the “Table of Contents” to find information on the tasks you

wish to perform for the system you’re diagnosing or configuring.

If you selected

BENDIX/KB/EATON ABS

and Brake-Link™

presents CAN NOT IDENTIFY ECU:

• the detected ECU is not a Bendix

EC-17, EC-30, EC-30T, Gen-

eration 4, or Generation 5 controller.

If you selected

EATON ABS

and Brake-Link™ presents CAN NOT

IDENTIFY ECU:

• the detected ECU is not a Bendix

Generation 4 or Generation 5

controller (formerly marketed by Eaton

If it returns ECU NOT RESPONDING and you’re using the

protocol:

• Brake-Link™ can’t find a supported ECU for the selected

MODE, e.g., you chose trailer while attached to the tractor and

the tractor and trailer ECUs reside on separate J1708 Buses.

Connect to the desired J1708 Bus and start again.

• you may have a loose connection; check all cables and reboot the

application.

• the ECU or Data Bus may not be working properly.

If it presents ECU NOT RESPONDING and you’re using the

protocol:

• the brake ECU may not be equipped with Enhanced PLC Mode;

attach Brake-Link™ to the applicable Deutsch Connector (i.e.,

tractor or trailer) and use the protocol.

• Enhanced PLC Mode may not be enabled on the ECU. Attach

Brake-Link™ to the applicable Deutsch Connector (i.e., tractor

or trailer) and use the protocol; then, see “Enabling En-

hanced PLC Mode”, on page 30.

• the ECU or Data Bus may be malfunctioning.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 111 112

Sem comentários

BENDIX GEN 4 GEN 5 ABS Manual do Operador Página 35